WolfPack SDS plus Manual De Instrucciones página 12

ADDITIONAL HANDGRIP AND DEPTH STOP
Only use your hammer/chisel drill with the additional handgrip
mounted, and always hold the machine in both hands.
• Unscrew the handgrip (12) by turning anti-clockwise, and turn the drill neck to the position
required.
• Then tighten the additional handgrip (12) back on by turning clockwise.
• To mount the depth stop (1), press release-knob (4) until the depth stop (1) fits into the opening
of the handgrip.
• Insert the depth stop (1) and lock into place by releasing the knob (4).
• Depending on the length of the drill bit, adjusting the depth stop will allow you to drill a series
of holes at a pre-set depth.
FITTING AND CHANGING BITS
Always unplug your drill from the mains before changing the bit.
• Your drill is equipped with an SDS-plus bushing system.
• Clean the bit shaft from dust and coarse dirt with a dry cloth before you insert the bit into
the bushing. Add a little grease (can supplied) to the shaft with a clean cloth or brush.
• Pull back the locking sleeve (3) and hold it.
• Turn the dust-free bit into the bushing as far as it will go, and release the locking sleeve (3).
The bit will lock in automatically.
• Give the bit a tug to make sure that it is secure.
• To release the bit, pull back the locking sleeve (3) and pull out the bit.
CHISELLING
Switch off your hammer/chisel drill's turning function before
you use your drill as a chisel.
• Press release-knob (13) and turn the turning stop switch
(6) with the arrow pointing to the marking (
the machine casing.
CHANGING THE CHISELLING POSITION
You can lock the chisel in various different positions.
• Insert the chisel into the tool holder.
• Turn the mode selector switch (6) to the position
marked ( ).
• Turn the application tool to the required chisel position.
• Turn the mode selector switch (6) to the position ( ).
With this, the tool holder is locked.
) on
12