cecotec FAST&FURIOUS 5060 ULTRA Manual De Instrucciones página 20

ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
1. Steam burst button
2. Spray button
3. Water inlet cover
4. Nozzle
5. Power cord protector
6. Top cover
7. Handle
8. Rear cover
9. Water tank
10. Self-clean button
11. Skirt
12. Temperature knob
13. Steam knob
14. Soleplate
2. BEFORE USE
Note: You may notice a slight burning smell or smoke when using the appliance for the
first time, caused by the excess of lubricants from the manufacturing process. Smoke will
disappear after a short time.
Take the product out of the box.
Remove packaging material, stickers and labels from the soleplate.
Clean the iron's soleplate with a soft cloth.
Inspect all parts of the appliance for visual damage. Unwind the power cord completely and
inspect it for damage.
Do not use the product if it or its cord have been damaged or are not working properly.
In case of damage, contact the official Technical Support Service of Cecotec for advice, repairs
or returns.
Make sure you have read and understood all instructions and warnings in this instruction
manual. Pay particular attention to the safety instructions on previous pages.
Place the appliance on an even, heat-resistant surface. Do not place the appliance near heat
sources, places with high humidity levels, or combustible materials.
Plug the appliance into an appropriate wall outlet. The plug must have easy access, so that in
case of an emergency, it can be easily unplugged.
38 FAST&FURIOUS 5060 ULTRA
3. OPERATION
Filling the water tank
Unplug the iron before filling the water tank.
Rest the iron on its heel rest, tilt it forward approximately 45º and fill the water tank up to the
MAX mark.
Tap water may be used. In case water is hard, use distilled water. Do not use chemically
descaled or scented water under no circumstance.
Mix 50 % of tap water with 50 % demineralised water. Do not use only demineralised water.
Vertical steaming
Ensure there is enough water in the tank.
Stand the steam iron vertically, rest it on its heel and connect it to the power supply.
Set the temperature and steam knobs to maximum.
Hold the iron vertically and press the steam burst button, an intense steam will be ejected
from the soleplate.
Dry ironing
Select the appropriate temperature according to the type of fabric.
Position 0: No steam
Steam ironing
Unplug the iron and fill it with water.
Fill the water tank.
Plug the power cord into the power supply.
Set the temperature knob to the maximum position to use the steam iron, otherwise, water
will leak from the soleplate.
The light indicator will turn off when the device has reached the right temperature.
Set the steam knob to the desired position.
Note: Synthetic fabric, nylon, synthetic silk and silk cannot be used with the steam iron,
otherwise it will damage the surface finish.
Steam burst
By pressing the steam burst button, an intense burst of steam is emitted from the soleplate.
This function can only be activated during high temperature ironing.
Note: To prevent the soleplate from leaking, do not keep the steam burst button pressed for
more than 5 seconds.
For optimal steam burst, do not press the steam burst button more than three times in a row
to prevent the iron from cooling. Leave a 1-minute rest between steam bursts.
ENGLISH
FAST&FURIOUS 5060 ULTRA 39