Publicidad
Idiomas disponibles
Idiomas disponibles
-
Remove mandrel screw and washer.
-
Place desired accessory over mandrel shaft and align the accessory hole with
mandrel hole.
-
Insert mandrel screw with washer through the accessory and mandrel shaft holes.
NOTE: The mandrel washer should be placed between the mandrel screw and
the accessory.
-
Tighten using the provided wrench. (See Figure 7)
If using the drum mandrel:
-
Align appropriate sized sanding drum over mandrel and push down to completely
cover drum end of mandrel.
-
Insert the small end of the provided wrench into the slot on top of the mandrel and
tighten the screw on the drum mandrel head to expand the drum and securely
hold the sanding drum in place. (See Figure 8)
If using the screw mandrel:
-
Align desired accessory hole with mandrel screw head.
-
Screw accessory into mandrel by twisting clockwise until secure. (See Figure 9)
Fig.7
Balancing Accessories
For precision work, it is important that all accessories be properly balanced. To
balance an accessory, slightly loosen the collet nut and give the accessory or collet
a 1/4 in. turn. Retighten collet nut and run the rotary tool. You should be able to tell
by the sound and feel if the accessory is running in balance. Continue adjusting in
this fashion until the best balance is achieved. Replace accessories if they become
damaged or unbalanced.
Fig.8
- 15 -
Fig.9
Publicidad
