GreenWorks PA321K Manual Del Operador página 9

8.5 INSTALL THE BATTERY PACK
WARNING
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read, know, and follow the instructions in the
battery and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
8.6 REMOVE THE BATTERY PACK
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
9 OPERATION
WARNING
Always wear eye protection.
English
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
9.1 START THE MACHINE
1. Push ON button.
9.2 STOP THE MACHINE
1. Push OFF button.
9.3 REPLACE THE SANDING SHEETS
Remove any dust or debris from the sanding plate to
attach a new sanding sheets.
1. Lift the sanding sheet from the side and pull it off of
the sanding plate.
2. Put the sanding sheet with the Velcro facing up on
the dust box.
3. Push the cams of the dust box into two holes of the
sanding plate.
4. Roll off the sanding sheet from the dust box.
5. Push new the sanding sheet tightly against the
bottom side of the sanding plate.
9.4 OPERATE THE MACHINE
Surface sanding
1. Start the machine.
2. Put it with the complete sanding surface on the
surface to be worked and move the machine with
moderate pressure over the workpiece.
The removal capacity and the sanding pattern are
mainly determined by the selection of the sanding
sheet, the preselected orbital stroke rate and the
applied pressure.
9
WARNING
EN