Argo X3I ECO PLUS 27 HL WF Manual De Instalacion Y Uso página 98

After-use checks
1. Disconnect the power supply.
2. Clean the indoor unit's panel and filters.
3. Check that the outdoor unit's support bracket is not damaged or corroded. If it is, contact the
service centre.
N.B.
1. Many packaging materials are recyclable materials. Please dispose of them in the appropriate
recycling unit.
2. If you want to remove the air conditioner, please contact your local dealer or local service
provider for the correct disposal method.
TROUBLESHOOTING
Possible faults and solutions
WARNING
Do not attempt to repair the unit yourself. Improper repair can cause electric shocks or fire. Disconnect
the unit from the power supply before contacting your local Technical Service Centre.
Carry out the following checks before contacting your Technical Service Centre:
Fault
Is there noticeable interference (e.g. static
electricity, stable voltage)?
Is the remote control within the signal
reception range?
The indoor unit
Are there any obstacles between the remote
does not receive
control and the receiver?
the signal from
Is the remote control pointed at the receiver? Point the remote control at the receiver on
remote control
or the remote
Is the remote control's sensitivity low? Are
control does not
icons blurred or missing?
seem to be
Do icons fail to appear on the display when
working
you operate the remote control?
Is there a fluorescent light in the room?
Is the indoor unit's air inlet or outlet blocked? Remove the obstruction.
In heat mode, has the indoor temperature
reached the set temperature?
No air comes
out of the
Has heat mode only recently been selected? To prevent blasts of cold air from being
indoor unit
Is there a power cut?
The air Has the plug come loose?
conditioner is
Has the circuit breaker tripped or has the
not working fuse blown?
Is the wiring faulty?
Check
98
Solution
Pull out the plug. After about 3 minutes
reinsert the plug and restart the unit.
The maximum signal reception distance is
8 m. The remote control will not work
beyond this distance.
Remove the obstacles.
the indoor unit.
Check the batteries. If the batteries are very
low, replace them.
Check if the remote control is damaged. If
it is, replace it.
Position the remote control next to the
indoor unit.
Turn off the fluorescent light and try again.
Once the set temperature has been
reached, the indoor unit will stop blowing
out air.
blown out, there will be a delay of several
minutes before operation begins (this is
normal).
Wait for the power to be restored.
Reinsert the plug.
Have the circuit breaker or fuse replaced
by a qualified technician.
Have it replaced by a qualified technician.