Publicidad
Idiomas disponibles
Idiomas disponibles
Anti-flood connection option
Proceed according to the following method to connect the anti-flood component to the equipment, if necessary:
Operating instructions
Remove the sealing cap, open the water mixer and adjust to a moderate amount of water flow;
Turn the equipment "on" at the switch. From now on, the waste disposal is working and available for use;
Insert food waste slowly. For the shredder to work efficiently, the waste must be in small pieces. It is normal for the
equipment to reduce the speed when it starts to crush the waste, as it adjusts the power of the twisting movement
(crushing speed) according to need;
At the end of the operation, keep the water running for another 30 seconds. This operation ensures that all waste
is discharged;
Do not use hot water with this equipment. Cold water is sufficient to ensure that waste food and fat, in the solid
state, is washed away;
If the "reset" button turns off while the machine is still working, wait a minute and click the "reset" button again.
The machine's power cable meets national requirements and does not need to be replaced. However, if necessary,
please contact a professional.
Note: The equipment uses a surrounding anti-jamming impeller, so it is normal for it to make some noise at the start.
Overflow connection
Dishwasher connection
RODI INDUSTRIES, S.A. |
1. Remove the block cap that closes the entrance to the
sink, located in the disposer;
2. This cap comes out easily with the help of a hammer and
screwdriver (do not use cutting tools);
3. Once it droppes into the equipment, remove the cap be-
fore installing the waste disposal (if you do not remove the
cap, it will be shredded when you turn it on).
17
PT
EN
FR
ES
Publicidad
