Kinderkraft UNITY Manual De Uso página 20

• Pull the shoulder strap through the red guide (B) under the headrest. Slide the guide locking
element of the guide to prevent the car belt from slipping out.
•Place the lap belt and
Tighten the vehicle seat belt by pulling the first
belt section. Make sure that the lap belt is
placed in the guides and fixed in the buckle. The
shoulder and the neck of the child
Tip: You can also change the height of the headrest when the seat is placed in the vehicle.
Make sure the vehicle safety belt buckle is not placed on the lap belt guide (E).
5.2 Installing the car safety seat in weight groups 2 and 3 using the vehicle 3-point safety
belts and extra attachments.
IMPORTANT The instruction manual of the vehicle manufacturer specifies the location of the
fixing points and other necessary information regarding the installation of the seat in the car.
The user MUST read the instruction manual of the vehicle manu facturer
• To facilitate the seat installa ti
point s.
• Pull both ISOFIX (I) attachments out of the seat base. To do this, pull and hold the release
button (K) and pull out the ISOFIX att achment
attachment on the other side of the seat
• Grab the seat with both hands and push both attachments to the attachment points in the
car seat until you hear a "click" of each ISOFIX attachment.
NOTE! The locking attachments are secure only when both button markers are completely
green.
• Pull and hold the release buttons (K) simultaneously to move the child seat backwards as far
as possible. Make sure that the back of the child
vehicle seat.
• Grab the child seat and make sure it is securely fastened without play. If it moves and ISOFIX
attachments slip out, repeat the previous steps.
• Then fasten your child using the vehicle seat belts. Details are described in the relevant part
under Section 5.1.
5.3 Removing the child seat {ISOFIX fastening system)
• Press the ISOFIX release buttons
released and the colour of the markers turns red. Pull in the ISOFIX arms back in the child seat
base.
6.1 Removing/putting on the cover
• Removing the headrest cover: Detach the fasteners on the back of the cover and remove it
from the headrest.
• Removing the backrest cover: Tilt the elastic loops securing the cover to the back of the seat
backrest and slide the cover of the child seat side panels
shoulder belt under the armrest using the lap belt guides (E).
. Make sure that the belt does not chafe the child's
on, slide the ISOFIX guides (L) on the vehicle seat support
.
(J) located on both ISOFIX ar
EN
section of the hip
stretched as low as possible over the child's
shoulder
. Repeat the steps above to pulI out the
seat adheres firmly to the backrest of the
.
20
belt, and then the
belt should pass between the
.
ms. The attachments are
shoulder
hips,
neck.