Descargar Imprimir esta página

PowerSmith Mag lithium MLHT12C Manual De Operario página 10

Publicidad

Idiomas disponibles

Idiomas disponibles

3. An extension cord should not be used unless absolutely necessary. Use of improper
extension cord could result in a risk of fire and electric shock. If extension cord must be
used, make sure:
a. That pins on plug of extension cord are the same number, size, and shape as those
of plug on charger;
b. That extension cord is properly wired and in good electrical condition;
c. That wire size is at least as large as the one specified in the table below.
Cord Length (Feet)
Cord Size (AWG)
Note: AWG = American Wire Gage
4. Do not operate charger with damaged cord or plug. Replace immediately.
5. Do not operate charger if it has received a sharp blow, been dropped, or otherwise
damaged in any way; take it to a qualified serviceman.
6.
Do not disassemble charger or battery cartridge; take it to a qualified serviceman
when service or repair is required. Incorrect reassembly may result in a risk of electric
shock or fire.
7. To reduce risk of electric shock, unplug charger from outlet before attempting any
maintenance or cleaning. Turning off controls will not reduce this risk.
8. Young children should be supervised to ensure that they do not play with the battery
charger.
9. If operating time has become excessively shorter, stop operating immediately. It may
result in a risk of overheating, possible burns and even an explosion.
10. If electrolyte gets into your eyes, rinse them out with clear water and seek medical
attention right away. It may result in loss of your eyesight.
AddITIONAL pRECAUTIONS FOR CHARGER & BATTERy CARTRIdGE
1. Do not charge Battery Cartridge when temperature is BELOW 10°C (50°F) or ABOVE
40°C (104°F).
2. Do not attempt to use a step-up transformer, an engine generator or DC
power receptacle.
3. Do not allow anything to cover or clog the charger vents.
4. Always protect the battery terminals when the battery cartridge is not used.
5. Do not short the battery cartridge.
6. Do not touch the terminals with any conductive material.
7. Avoid storing battery cartridge in a container with other metal objects such as nails,
coins, etc.
8. Do not expose battery cartridge to water or rain.
Warning:
a battery short can cause a large current flow, overheating, possible burns
and even a breakdown.
9. Do not store the tool and Battery Cartridge in locations where the temperature may
reach or exceed 50°C (122°F).
10. Do not incinerate the Battery Cartridge even if it is severely damaged or is completely
worn out. The battery cartridge can explode in a fire.
11. Be careful not to drop, shake or strike battery.
12. Do not charge inside a box or container of any kind. The battery must be placed in a
well ventilated area during charging.
Operation
Always Check that the power supply corresponds to the voltage on the ratings plate on
your charger.
English
25ft.
50ft.
16
10
100ft.
12
12

Publicidad

loading