Philips AUT7006 Manual Del Usuario página 8

3. Installing the system
Note:
Please check if there is sufficient space for installing the system itself, its accessories,
connections, and for servicing and repair. Under no circumstances should the system
be installed outdoors. The environment where the system is installed should adhere to
any appropriate hygiene and sanitation conditions. Avoid any external dripping liquids
from pipes or drains etc onto the system.
This system should be placed on a stable and �at surface. Keep the system away from heat.
It shall not be placed in a place that may have in�ammable gas leakage.
a. Press down the collets and pull out the plugs
of the water inlet and outlet holes in the back
of the system.
b. Connect the water inlet and the three-way ball valve.
Measure the length of the 3/8" pipe you need to connect the system and the
three-way ball valve, and cut it accordingly with a pipe cutter. Insert the other end of the
3/8" pipe which has been connected with the three-way ball valve into the water inlet
hole in the back of the system. Use a clip to secure the pipe at the hole.
Note: The inlet water pressure should be within 0.1-0.4 MPa. If the pressure is too low,
a pressure booster should be installed prior to the system. If the pressure is too high,
a pressure relief valve should be installed prior to the system.
6