Oregon 410-120 Manual Original De Instrucciones página 12

SETTING THE SHARPENING ANGLES
FOR LEFT-HAND CUTTERS WITH A DOWN ANGLE
This section describes how to adjust the grinder for those chain types that require a down angle
setting To find out which chains require this setting, consult column B in the chain chart on page 12
SETTING THE DOWN ANGLE
Find the correct angle using the
"Grinding Angles Chart" on page 12
Loosen the vise adjustment knob (16)
Pull the vise adjustment knob (16) towards
you and up as far as it will go to rotate vise
22
410-120
LEFT-HAND CUTTERS
SETTING THE VISE ROTATE ANGLE
Turn the vise counter-clockwise
Position the reference mark pointer (17) on
the vise by the desired vise rotate angle
Tighten the vise adjustment knob (16)
410-120
SETTING THE HEAD TILT ANGLE
Loosen the locking knob (H) at the
back of the motor unit (A)
Rotate the entire motor unit (A) until the
reference mark on the edge of the arm is
positioned at the desired head tilt angle (11)
Tighten locking knob (H) at the
back of the motor unit (A)
SETTING THE SHARPENING ANGLES
23