Publicidad
Idiomas disponibles
Idiomas disponibles
sunlight.
6.
Keep the torch beyond reach of chil-
dren.
7.
Fill the microtorch only with butane gas.
8.
Protect the microtorch against oil, acids
and other chemical agents.
9.
When operating the microtorch always
use personal protection measures:
protective glasses and gloves.
10.
Do not use the microtorch continuously
for more than 5 minutes.
11.
Do not use damaged microtorch.
12.
Do not repair the microtorch by your-
self, do notdismantle parts of the
microtorch.
13.
Use the microtorch accordingly to the
manual.
WARNING!
–
Do not use soldering joints for elements
or materials that may be subject to
temperature above 130°C.
–
Do not join parts used for lifting weights
with solder joints.
–
Do not solder electrical wires with open
flame, high temperature may damage
insulation.
CAUTION!
Gas refill valve must not be
damaged.
CAUTION!
All checks and repairs should be
carried out by the supplier's service
department or by service site
certified by the supplier. Make all
checks and repairs only after the microtorch
is gas emptied.
CAUTION!
It is recommended to carry out few
soldering tests on waste pieces of
soldered material. Soldering skills
come with practice
TOPEX.PL
INTENDED USE
Microtorch design is compact, it fits in hand
and allows working in places unavailable for
large gas torches. Gas supply allows working
in places where no other energy source is
available at tasks that require higher heating
temperature.
TECHNICAL PARAMETERS
Max. flame temperature
Operation time after gas refilling
Time of intermittent operation S3
Gas container capacity
Gas type
Weight
TOOL PARTS (fig. 1)
a. Nozzle
b. Gas valve wheel
c. Piezo ignition button
d. Removable stand
OPERATION AND USE
filling the microtorch container with
gas (fig. 2)
Fill the gas only when the microtorch is
switched off.
Make sure the gas valve wheel is turned off.
Remove the stand from the microtorch.
Turn the microtorch over so the gas refill
valve is on top.
Use required adaptor and press the gas
cylinder valve tip against the microtorch
valve. The container will be filled in
approximately 10 seconds. When the
microtorch flame significantly weakens or
fades out, the gas container is emptied.
Starting the microtorch
Direct the microtorch nozzle forward.
Turn the microtorch gas valve by 2/3 of
a turn in (+) direction (you should hear
specific hissing when the gas comes out
of the nozzle).
7
Approx. 1300°C
Approx. 45 min
5 min
operation/5 min
break
28 ml
Butane
140g
Publicidad
