Publicidad
Idiomas disponibles
Idiomas disponibles
Before use
Q
Assembly
Q
WARNING!
Only operate the product after it has been
u
completely assembled and adjusted!
NOTE
Assemble the product completely and make all
u
required adjustments prior to operation.
Follow the assembly and operation instructions
u
closely. Use the figures as visual guide.
Pay attention to small parts such as screws and
u
nuts that are loosen or removed for assembly or
during adjustments. Keep them safe in order to
avoid losing them.
Attaching the front handle
1.
Align the front handle
and slide it upwards onto the upper pole
(see Fig. D).
2.
Ensure the front handle
place.
Attaching the plant protector
1.
Slightly widen the open end of the plant
protector
, align the metal rod ends with
15
the holes on the trimmer head
snap into it (see Fig. E). Pay attention to the
correct orientation!
2.
Ensure the plant protector
place and can be folded up and down.
Attaching the wheel assembly
NOTE
The plant protector
u
upwards so that the wheel assembly
be mounted.
1.
Align the wheel assembly
holder on the trimmer head
downwards (see Fig. F).
2.
Ensure the wheel assembly
in place.
32 GB / IE
8
with its bracket
7
6
sits properly in
7
and let it
17
sit properly in
15
must first be folded
15
can
14
14
with its
and slide it
17
14
sits properly
Attaching the guard
The plant protector
must be folded upward,
15
before the wheel assembly
1.
Turn the trimmer head
2.
Align the latches on the guard
edges on the trimmer head
into place.
3.
Secure the connection with the provided
screws and a suitable screw driver
(see Fig. G).
Attaching / removing the
Q
battery pack
Attaching the battery pack:
1.
Align the battery pack
compartment
and slide it onto it. Ensure it
1
clicks noticeably in place.
Removing the battery pack:
1.
Press the release buttons
battery pack
.
27
Charging the battery pack
Q
NOTE
The battery pack
27
u
Charge the battery pack
ideally at least 60 minutes.
Always pull out the plug of the charger
u
from the mains before removing or
connecting the battery pack
charger.
Never charge the battery pack
u
the ambient temperature is below 10 °C or
above 40 °C.
Never recharge a battery pack
u
immediately after rapid charging. This could
overcharge the battery pack
reducing the lifespan of the battery pack
and charger
.
31
Rest the charger
31
u
between successive charging sessions.
If no battery pack
u
charger
and the charger is connected to
31
mains, the charging status LED
green.
14
can be assembled.
upside down.
17
to the
13
and slide it
17
to the battery pack
27
and remove the
29
comes partly charged.
prior to first use,
27
31
to the
27
when
27
again
27
, thus
27
27
for at least 15 minutes
is inserted into the
27
flashes
32
Publicidad
