Dantherm Master Climate Solutions CCX 4.0 Manual Del Usuario página 15

►1.22. Conditions of use:
A) Air temperature: 18°C to 45°C;
Water temperature: <45°C.
B) The air supply must be free
of dust, pollutants, or additional
cleaning should be used.
►1.23. The water used to fill the cooler
tank must come from an aqueduct.
If it is not possible to draw from
an aqueduct, the water introduced
must be subjected to a sanitation
treatment, according to European
Directive 98/83/EC.
-We recommend using water with a
hardness of less than 15°f.
-The cooler tank must be emptied
and sanitised periodically depend-
ing on the use.
-The cooling pad surfaces must be
periodically inspected and sanitised
depending on the use.
-For sanitation operations, biocidal
products that comply with Europe-
an regulation no. 582/2012 must be
used.
►►2. UNPACKING
►2.1. Remove all packaging materials
used to wrap and deliver the appliance
and dispose of them in compliance
with the Standards in force.
►2.2.
Extract all
packaging.
►2.3. Verify if damage undergone during
transport. If the appliance appears
damaged, inform the dealer, where the
purchase was made, immediately.
►►3. ASSEMBLY
The device is equipped with wheels to
facilitate handling. Depending on the
model, wheels can be found already
installed or not. Components equipped
with relative nuts and bolts are found
inside the packaging (Fig. 1).
Figures and texts of this book are protected by COPYRIGHT.
items from the
►►4. OPERATION
WARNING: Thoroughly read the
"INFORMATION
SAFETY", before switching the
appliance on.
WARNING: Only use clean water to
prevent failures or other anomalies.
WARNING: Verify if your electronic
system is earthed
Connection to the mains must
be made in compliance with the
National Standards in force. Power
the appliance only with voltage and
frequency as specified on the data
plate.
NOTE: These
connected to the water mains, by
connecting the pipe to the fitting
(Fig. 13).
►►4.1. SWITCHING ON:
►4.1.1. Open the tank door (Fig. 2).
►4.1.2. Fill the tank with water (Fig. 3);
water level must be within MIN and
MAX level of the graduated scale (Fig.
4), in order to prevent risks.
►4.1.3. Close the tank door (Fig. 5).
►4.1.4. Connect the power plug to the
mains (Fig. 6).
►4.1.5. Press the ON/OFF button to
switch on the appliance (Fig. 9).
►►4.2. CONTROL PANEL, USE
AND FUNCTIONS (Fig. 7-8):
►ON/OFF: Allows turning on or off the
cooler.
►SPEED: Increases or decreases the
ventilation speed of the device. You
can choose from three speeds: LOW,
MID and HIGH.
►COOL: Enables or disables the cooling
mode.
►SWING: Enables or disables the
automatic swing of the fins to direct the
air flow.
REGARDING
correctly.
models can be
en