Dantherm Master Climate Solutions CCX 4.0 Manual Del Usuario página 16

en
►ANION: Enables or disables the
ionisation mode, that is, the release
of negative ions in the atmosphere, to
make air healthier.
►TIMER: Enables or disables the timer
for automatically turning the cooler off
(from 1 to 9 hours).
NOTE: When the control panel
display shows the icon "DROP"
(flashing), accompanied by a beep,
it means that the tank is empty and
must be refilled to reactivate the
"COOL" function.
►►4.3. SWITCHING OFF:
►4.3.1. Press the ON/OFF button to
switch off the appliance (Fig. 9).
►4.3.2. Empty the tank using the drain
cap (Fig. 10-11-12).
►►5. CLEANING AND
MAINTENANCE
WARNING: BEFORE PERFORMING
ANY MAINTENANCE OR REPAIR,
DISCONNECT THE POWER CABLE
FROM THE MAINS.
DEPENDING ON THE ENVIRONMENT
WHERE THE APPLIANCE IS USED,
DUST, DIRT OR WATER QUALITY CAN
AFFECT THE PERFORMANCE OF THE
UNIT. THEREFORE, CLEANING THE
FOLLOWING COMPONENTS CAN BE
NECESSARY:
►►5.1. TANK:
We recommend changing the water
frequently.
►5.1.1. Switch off the appliance and
remove the plug from the mains (Fig.
9-6).
►5.1.2. Remove the drain plug in order
to empty the tank (Fig. 11-12-13).
►►5.2. FILTERS:
It is recommended to clean the filters
frequently.
Figures and texts of this book are protected by COPYRIGHT.
WARNING: Dirty filters can lead to
a significant drop in performance
of the device.
►5.2.1. Switch off the appliance and
disconnect the plug from the mains
(Fig. 9-6).
►5.2.2. Remove the filters upwards (Fig.
14).
►5.2.3. Clean the filters using a mild
detergent and a clean cloth (Fig. 15).
Ensure the filter is fully dry.
►5.2.4. Place the filter back into its
housing (Fig. 16).
►►5.3. WATER CIRCUIT:
►5.3.1. To ensure proper operation of
the cooler, turn off COOL mode a few
minutes before completely switching
off the appliance, in order to avoid
stagnant water.
►5.3.2. Once a month we recommend
performing a complete cycle using
clean water and appropriate disinfection
products, running the cooler outdoors.
IMPORTANT:
-The cooler tank must be emptied and
sanitised periodically depending on
the use.
-The cooling pad surfaces must be pe-
riodically inspected and sanitised de-
pending on the use.
-For sanitation operations, biocidal
products that comply with European
regulation no. 582/2012 must be used.