Publicidad
Idiomas disponibles
Idiomas disponibles
GB
Features:
1 Characterized with a general power switch to allow this unit be power off
when is not in using.
2 Two heatings and cool shot.
3 Slightly press on the spring button to turn on and work, release that switch
to turn off. (fig. 1)
1 dryer body
3 spring button
Warning: Don't install the hair dryer in the places easy wet.
How to install this unit with plug connected wire:
1 Drill 2 holes of 6 mm diameter according to the dimension shown in fig. 2
then insert toggle into that holes and fix its hanger to top hole.
2 Align installation cilp on the back cover to the hanger and push down, fix
front and back cover on wall with the screw, then insert toggle into screw hole.
How to install this unit without plug-connected wire:
1 As per first step of the method above.
2 Loosen the screws as per fig. 3 to remove front cover and remove to
plug-connected wire from terminal.
3 Open the wire entry hole; pull the reserved wire through that hole. Then align
installation clip on the back cover to the hanger and push down, fix back cover
on wall with the screw
4 Fix the reserved wire on terminal, please notice its direction of N,L wire, re-
place terminal to its original position
5 Fix front cover after checking that there is no mistake.
1
2
3
4
Fig. 1
2 switch
4 holder
17,5 cm
Fig. 2
18
Fig. 3
Publicidad
