Publicidad
Idiomas disponibles
Idiomas disponibles
8. Maintenance
Maintenance, replacement, or repair of the
emission control device and systems may be
performed
by
any
establishment or individual.
WARNING
• Always be sure to stop the engine before
inspecting the brush cutter for problems or
performing maintenance.
• Never alter the brush cutter or take the engine
apart.
■ REFILLING TRIMMING LINE
1. For replacement line, use a diameter of 3.0mm,
and length285mm. Avoid using a larger line as it may
cut down the trimming performance.
2. Insert the line to the hole on the trimmer head
with force, and make the line goes the direction and
through the other hole on the top.
3. Leave the length of outside line at 150~160mm.
4. If the lines are too short as the use of the
machine, pull out the trimmer line and replace
with new lines.
■ AIR FILTER
The air filter, if clogged, will reduce the engine
performance. Monthly check and clean the filter
element in warm, soapy water as required. Dry
completely before installing. If the element is broken
or shrunk, replace with a new one.
non-road
engine
repair
(1) Air filter
■ FUEL FILTER
•
When the engine runs short of fuel supply,
check the fuel cap and the fuel filter for blockage.
■ SPARK PLUG
•
Starting failure and mis-firing are often caused
by a fouled spark plug. Periodically clean the spark
plug and check that the spark gap is in the correct
range.
•
When you take off the spark plug, twist (1) and
pull off the cap (2).
IMPORTANT
•
Note that using any spark plugs other than
those designated may result in the engine failing to
operate properly or in the engine becoming
overheated and damaged.
•
To install the spark plug, first turn the plug until
it is finger tight, then tighten it a quarter turn more
with a socket wrench.
TIGHTENING TORQUE: 9.8~11.8 N.m
13
Publicidad
