Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
2.
Charging terminals
3.
Silicone water tank cap
4.
Tank lock
5.
Mop bracket
Note:
This product images, accessories, user interfaces, etc. that are shown in this manual are
reference images. The actual product may be slightly different to the images due to product
updates and improvements. If so, the actual product will prevail.
2. BEFORE USE
−
Take the product out of the box and remove all packaging materials.
−
Check carefully if there is any damage. If any is observed, contact as soon as possible the
Technical Support Service of Cecotec for advice or reparation.
3. INSTALLATION
Robot and charging base installation
Connect the charging base to a power supply and store the remaining cable. It is important to
store the remaining cable at the bottom of the charging base to avoid it from being dragged
and disconnected.
Place the charging base against the wall, leaving the safety distance indicated in figure 4
Note:
Ensure a space of at least 0.5 m on both sides of the charging base, and 1.2 m in front of it.
Warning
Do not expose the charging base to direct sunlight.
Hold down the power button for 3 seconds; when the indicator light turns on, place the robot
on the charging base.
Warning
−
Take the robot to the charging base if the battery is low. The robot might not turn on if the
battery is very low.
−
The robot will automatically turn on when placed on the charging base.
−
The robot cannot be turned off during charging.
34
Wet & dry tank installation
Warning
−
It is not suggested to use the scrubbing function for the first-time use.
−
Open the tank silicone cover, fill the tank with water carefully so water does not come
out. Make sure the silicone cover is properly closed to avoid water from leaking. Do not
immerse the tank. Fig. 5.
−
Install the tank in the robot following the indicated direction. Make sure the clip is properly
fastened.
−
Manually press the tab and push it into its correct position. You will hear a click when it is
properly fixed. Fig. 6.
Recommendations:
−
Do not use the scrubbing function while the robot is unattended.
−
Remove the mop bracket when the robot is charging or not in use.
−
Add some drops of cleaning agent (not corrosive) if considered necessary.
−
To remove the mop bracket, press the release button and pull from it outwards.
Warnings:
−
Using cleaning agents in excess might block water outlets.
−
In order to achieve perfect scrubbing, it is suggested to moisten the mop before using it.
First cleaning
−
Once the robot vacuum cleaner and the charging base are completely installed, follow
these steps before scheduling the first cleaning cycle.
−
First of all, the robot must be fully charged. It is suggested to allow the robot to charge
overnight. When it is fully charged, it may carry out the first cleaning cycle and save the
first map. To do so, activate Auto cleaning mode and Eco suction level. It is very important
to follow these indications for the robot to recognize each and every corner in the house
and to create a complete map.
−
If your house is too big and the robot runs out of battery, it will return to the charging base,
save the full map and those that have not been completed, and once it is charged again, it
resumes the cleaning cycle from the point it has stopped until it maps the whole surface.
The robot keeps on mapping constantly, therefore it adapts independently to each house's
features and continuously improves previous maps.
4. OPERATION
−
The indicator light will change from oscillating blue to steady blue when the battery is fully
charged.
−
The robot cannot operate with low battery.
ENGLISH
35
Publicidad
