Publicidad
EN
Charging procedure
i
NOTICE Please read the charging instructions in the vehicle's manual before using the charging station.
WARNING The plug locks to the vehicle inlet when charging starts. The plug stays locked until the
charging procedure is finished. Always complete or end charging in the vehicle before unplugging (refer
to the vehicle's charging instruction for information about this).
Plug In
READY
READY
PREPARING
PREPARING
PREPARING
9
9
9
9
9
9
9
400V 3-PHASE 32 A
400V 3 PHASE 32 A
400V 3 PHASE 32 A
400V 3 PHASE 32 A
400V 3 PHASE 32 A
400V 3 PHASE 32 A
400V 3 PHASE 32 A
CHARGING
CHARGING
CHARGING
PREPARING
CHARGING
PREPARING
PREPARING
CHARGING
PREPARING
PREPARING
CHARGING
PREPARING
CHARGING
PREPARING
i
NOTICE The plug must be fully inserted into the inlet of the vehicle. Failure to connect will prevent the
vehicle inlet from locking the plug in place and start charging.
12
1. Pick up the plug, uncoil the cable, and remove the plug cap
2. Make sure that the charger is ready to be used. The Charger
Ready icon should be visible on the display.
3. Insert the plug into the vehicle inlet. The following symbol should
now be visible on the display to indicate that charging is initialized.
- If authorization is enabled, that process has to finish before
charging can begin. See the chapter Authorization for more
information.
4. Make sure that charging has started. The following symbol should
now be visible on the display.
Unplug
WARNING Complete or stop the charging process before unplugging. To stop charging before the
vehicle is fully charged, see the vehicle's manual.
Unlock the plug from the vehicle, refer to the vehicle's manual for more information.
1. Remove the plug from the vehicle inlet.
2. Put on the plug cap onto the plug.
3. Insert the cable into the clip.
Once the charger is disconnected, the display will show a summary of the charging session.
Authorization
If authorization is needed this icon will be shown on the display:
The authorization process can be completed by either:
1. Scanning your RFID-tag on the RFID-scanner, if the charger is registered to your account in the user application.
2. Opening the user application on your phone or scanning the QR code shown on the display. Follow the instruc-
tions shown on the screen.
If the authorization fails this icon will be shown on the display:
Check your user application or contact customer support of the facility.
defa.com
defa.com
116.3
ID E213604
DONE
DONE
228231 kWh
EN
13
Publicidad
