Publicidad
Warning! Do not over-tighten the screws. If you encounter resistance while you're
tightening the screws, stop tightening. Failure to do so could result in damage to the
TV.
1. If you're attaching a TV with an inset mounting surface, place the spacers over the
mounting holes on the back of the TV.
2. With the knobs facing outwards, position the left (2) and right (3) brackets so that
the holes on the brackets line up with the mounting holes or spacers on the back of
the TV.
3. Position the four washers (10) over the holes on the left and right brackets. (figure 2)
Note: There are small and large holes in the washers to accommodate different screw
sizes.
4. Insert the screws into the washers, the left and right brackets, the spacers (if
required), and into the back of the TV.
5. Use a screwdriver to tighten the screws. (figure 2)
figure 2
Instruction manual
Screw
Washer
9
Bracket
TV
Screw
Washer
Bracket
Spacer
Publicidad
