Publicidad
Idiomas disponibles
Idiomas disponibles
LIdL GV51XX E0 GTE_110x154 07/02/11 16:13 Page20
Description
1.
Steam control dial
2.
Iron temperature adjustment button
3.
Temperature setting mark
4.
Thermostat light
5.
Iron rest
6.
Boiler cap
7.
Boiler (inside the base-unit)
8.
Steam cord storage space
Preparation
What water to use ?
•
Your iron has been designed to operate using untreated tap water.
However, it is necessary to operate the Self-Clean function regularly
in order to eliminate hard water deposits from the steam chamber.
•
Types of water not to use: Heat concentrates the elements contained
in water during evaporation. The types of water listed below may
contain organic waster, mineral or chemical elements that can cause
spitting, brown staining or premature wear of the appliance: water
from clothes dryers, scented or softened water, water from
refrigerators, batteries, air conditioners, rain water, boiled, filtered or
bottled water. These types of water should NOT be used in your
TEFAL steam generator. Also only use distilled or demineralised water
as advised left.
•
Ironing Boards: Due to the powerful steam output, a mesh type
iorning board must be used to allow any excess steam to escapte and
to avoid steam venting sideways.
•
Place your steam generator on a flat, stable, heat-resistant surface.
•
Check that your appliance is unplugged and cold.
•
Unscrew the boiler cap.
•
Using a water jug, fill with maximum 1 litre of water. Fill the boiler, taking care that the water does not
spill over (A). If this occurs, remove the excess water.
•
Replace the boiler cap, screwing on firmly, but not over tight.
Using the Easycord system
•
Your iron is equipped with an extension cord system to prevent the
cord from dragging over the laundry and creasing it again when
ironing.
•
Take the steam cord out of its housing and unwind it completely.
•
Remove the tie to release the cord outlet.
•
Press the Eject button (B) and the Easycord system extends
automatically.
•
When the cord outlet tips, the Easycord system extends
automatically without you having to press the Eject button.
The first time the appliance is
used, there may be some fumes
and smell but this is not
harmful.
They will not affect use and will
disappear rapidly.
20
9.
Easycord system (according to model)
10.
Steam cord
11.
Electric cord tidy
12.
Power cord
13.
Steam flow adjustment dial (accord. to model)
14.
Illuminated on/off switch
15.
Steam ready indicator light (accord. to model)
(according to model)
•
Unwind the electric cord completely and take the steam cord out of its
housing.
•
Connect your generator to an earthed socket.
•
Press the on/off luminous switch. It comes on and the boiler heats up.
•
After approximately 8 minutes or when the steam ready indicator light
comes on (according to model), the steam is ready.
•
During ironing the iron's thermostat light and the steam indicator (accor-
ding to model) will go on and off according to the temperature control.
If your water is very hard
(check with your local water
authority) it is possible to mix
tap water with store-bought
distilled or demineralised water
in the following proportions :
50% untreated tap water, 50%
distilled or demineralised
water.
Filling the boiler
Always use the Easycord
system for enhanced comfort
of use.
Starting the generator
Publicidad
