Publicidad
Idiomas disponibles
Idiomas disponibles
If the circulation pump is not slaved to the filtration pump, shunt the two terminals using the shunt provided.
When a heating demand is detected the circulation pump will start up even if the filtration pump is not
running.
CAUTION:
To prevent heating of the termninals, ensure that the terminal screws are well tightened.
Plug the male connecter into the female connector.
CAUTION:
The heat exchanger seal ensures leaktightness of the heating circuit. The two nuts on the body of the heat exchanger
should under no circumstances be loosened. Failure to comply with this instruction could lead to cancellation of
guarantees.
Primary circuit
•
The cross section of the primary circuit will be calculated based on the rate of flow into the heat exchanger
(refer to the technical specifications of the various models).
IMPORTANT
When tightening (or loosening) the primary circuit connections on the exchanger's brass unions, hold the unions steady
using a wrench to prevent any movement. Any rotation of the brass unions could damage the plastic body of the heat
exchanger and give rise to a leak, cancelling any guarantees.
Secondary circuit
•
The secondary circuit is plumbed into the pool return line, preferably on a by-pass, after the filter and
before the injection of any chemical products.
•
Make the necessary provisions to cope with the risk of freezing during winter, notably ensure that it is
possible to drain the secondary circuit completely (by means of a drain valve mounted on the installation
or by loosening one of the unions on the heat exchanger).
CHAUFFAGE ET DÉSHUMIDIFICATION
Live
Neutral
Earth
Filtration
contact
NO
2021/07 - Indice de révision : K - Code : 33035
Slaving the exchanger
circulation pump to the
filtration pump.
19/56
Publicidad
