Stanley STHT77616 Manual Del Usuario página 12

Position one of the laser tool's 5/8"‑11 screw holes
3.
GB
(Figure Ⓖ) over the tripod's 5/8"‑11 mounting
screw and tighten the mounting screw.
CAUTION: Do not leave the laser tool
unattended on a tripod without fully tightening
the mounting screw. Failing to do so may lead to
the laser tool falling and sustaining damage.
Target Card
Some laser kits include a plastic Laser Target Card
(Figure Ⓛ) to aid in locating and marking the laser
beam. The target card enhances the visibility of the
laser beam as the beam crosses over the card. The
card is marked with standard and metric scales. The
laser beam passes through the red or green plastic
and reflects off the reflective tape on the reverse side.
The magnet at the top of the Target Card is designed
to hold it to ceiling tracks or steel studs to determine
plumb and level positions. For best performance when
using the Target Card, the front of the card should be
facing you.
Laser Enhancement Glasses
Some laser kits include Laser En hancement Glasses
(Figure Ⓙ). These glasses improve the visibility of
the laser beam under bright light conditions or over
long distances when the laser is used for interior
applications. These glasses are not required to operate
the laser.
CAUTION:
These glasses are not ANSI approved safety
glasses and should not be used while operating
other tools. These glasses do not keep the laser
beam from entering your eyes.
CAUTION:
To reduce the risk of serious injury, never stare
directly into the laser beam with or without these
glasses.
12
Turning the Laser On
The laser tool can be turned on in Self-Levelling Mode,
Manual Mode, or in the Vertical Position.
Use To
Self-Leveling Mode Place the laser tool on an uneven
surface.
Manual Mode Position the laser tool at any angle.
Vertical Position Reposition the laser tool by 90°.
Self-Leveling Mode
Self-Levelling Mode allows the laser tool to
compensate for placement on an uneven surface up
to 4°.
Place the laser tool on a smooth, flat, level surface.
1.
Position the laser tool horizontally (Figure Ⓐ).
2.
Move the Lock Switch to the left to select Self-
3.
Leveling Mode (Figure Ⓜ ①).
Press to turn the laser tool ON.
4.
Do not look into the laser beams as they turn on.
5.
• The rotary laser beam turns on (Figure Ⓐ ①).
• The Plumb Up Dot laser beam turns on from the
top of the laser tool (Figure Ⓐ ②).
On the keypad, make sure
6.
GREEN. If is flashing RED, the battery level is
low.
Allow the laser tool 5 seconds to self-level.
5.
If the laser is within its 4° compensation range:
6.
• The rotary laser beam starts to rotate
(Figure Ⓐ ①).
• On the keypad, remains off (Figure Ⓗ ①).
• The laser tool is level and ready for use.
(Figure Ⓗ ②) turns