Faraone QUATTRO T14 Manual Del Usuario página 27

ATTENTION!
Before using the ladder, read carefully the general norms
(from page 36 to page 44).
5.6 SCALA TELESCOPICA MULTIUSO IN ALLUMINIO
MAX 150 Kg
EN 131.4 D.L. 81
When the ladder is extended,
as shown in FIG 1, do not use it
at a height greater than the one
advised.
AT LEAST TWO STEPS SHOULD
ALWAYS OVERLAP.
If you want to lean the ladder
against a wall.
1) Lie the ladder down on the ground
2) Put the handle of the hinges in the
holes marked "open" .
3) Open the ladder fully, inserting the
handle. Make sure the "locking
handle" is enabled (see photo B).
4) Insert the outriggers (to ensure
compliance with standard 131.2
2018. See paragraph 5.0 on
page 44)
If you want to further extend
the ladder.
1) Pull the red side dowels out of
the holes in the step, then turn
them half-way so they remain out.
The ladder can now be extended;
2) Extend the ladder elements to
the required height. At least 2
steps should overlap;
3) Re-insert the dowels in their holes
in the steps at the required height;
4) Put the ladder against the wall
with the central articulated joint
facing the wall;
Next >
OPERATING AND SAFETY INSTRUCTION MANUAL . 52
Fig. 1
C. ACTIVE D. NOT ACTIVE
A
C. ACTIVE D. NOT ACTIVE
STA-T3
Kit assembly
ATTENTION!
Before using the ladder, read carefully the general norms
(from page 36 to page 44).
5) If the ladder is more than 2 m
high, attach the ladder to a solid
structure to prevent it from tipping;
6) Insert the outriggers (to ensure
compliance with standard 131.2
2018. See paragraph 5.0 on
page 44)
If you want to use a shears ladder
A
(double ladder).
1) Lie the ladder down on the ground
2) Place the "locking handle" of the
hinges in the holes marked "free
shears" position A or "fixed
shears" position B ;
3) Open the ladder to release the
"locking handle". Make sure the
"locking handle" is enabled (see
photo C);
4) Position the ladder;
5) Insert the outriggers (to ensure
compliance with standard 131.2
2018. See paragraph 6.0 on p. 44)
If you want to further extend
the ladder.
1) Follow the same instructions on
configuring the "aluminium
telescopic ladder" for use against
C. ACTIVE
a wall (steps 1 to 3)
2) Insert the anti-opening belt.
Attach the snap-hook.
Make sure the belt is in good con-
dition and properly taut, otherwise
it will not work correctly.
3) Position the ladder.
C. ACTIVE
4) If the ladder is more than 2 m
high, attach the ladder to a solid
structure to prevent it from tipping;
5) The ladder is now ready for use;
In this case you can adjust the
height of one of the strut elements
if the ground is on an incline.
Next >
53. OPERATING AND SAFETY INSTRUCTION MANUAL
CAUTION:
Make sure
the ladder
is not
extended
more than
permitted.
B
03
33
D. NOT ACTIVE
D. NOT ACTIVE
OK!
NO!
65