Publicidad
Idiomas disponibles
Idiomas disponibles
ATTENTION!
Before using the ladder, read carefully the general norms
(from page 36 to page 44).
5.6 ALUMINIUM TELESCOPIC MULTI-PURPOSE LADDER
The hinged ladder has a special removable step/
platform with safety parapet.
This can be mounted either on the outside part
or on the removable inside part by extending the
ladder by at least 2 steps. Pull the locking device
at the centre of the step/platform and lock the
step above the rung of the ladder, making sure
the locking device clicks back into place.
N.B. The handrail cannot be attached to
two different rungs
5.7 TELESCOPIC SAFETY WORK PLATFORM MOD. PLS
MAX 150 Kg
EN 131.7
D.L. 81
1) Open the ladder until the work
surface reaches the horizontal
position.
How to further raise the ladder:
2) Pull the red plugs on the side
(fig. A). Once they come out
of the step cavity, rotate them
by half a turn, so that they still
protrude and let the
ladder slide.
3) Open the safety rail
and couple it to the pin located
on the profile (fig. B).
4) Rotate and open the
outriggers (fig. C).
5) When the outrigger reaches
the floor, lock it in place by tur
ning the knob (fig. D).
6) Climb onto the ladder and close
the protection (fig. E).
To close the ladder, pay
attention to the following:
1) Close the outriggers (fig. F).
It is essential to close the
protection by uncoupling the
safety pin and rotating the rail
towards the back of the ladder.
OPERATING AND SAFETY INSTRUCTION MANUAL . 54
AVAILABLE ARTICLES
Mod. PLS
PLS3 - PLS5
A
B
D
E
The outrigger
is fixed by con-
necting the rail
to the hinge with
the bolt (fig.G).
F
ATTENTION!
Before using the ladder, read carefully the general norms
(from page 36 to page 44).
5.8 PROFESSIONAL STEPLADDER.
EN 131.1
D.L. 81
EN 131.2
1) Open the ladder so that the top
board is in place andthe safety
belt is fuilystretched.
2) Place the ladder whereneeded.
3) For ladders higher that 2 meters,
anchor the ladder toa solid
structure to avoid any turnover
risk.
4) At this point the ladder is ready
to be used.
WARNING! MAKE SURE THAT THE
BELT IS INTACT BEFORE THE USE.
5.9 LADDER FOR WAREHUSES MOD. SM
MAX 150 Kg
C
EN 131.7
STABILISING BAR ASSEMBLY
1) Fit the stabilising bases onto the
relative positions of the front and
rear element (1).
2) Block the stabilising bases with
the 2 through-bolts and nuts
self-locking
NO NOT TIGHTEN EXCESSIVELY to
avoid deformation.
3) Open the ladder so that the
landing is flat
4) Assemble the two side handrails
and the top railing.
5) Secure the side bars with the
wheels (2).
6) Position the ladder.
G
The ladder is now ready for use.
MAX 150 Kg
AVAILABLE ARTICLES
Mod. LADY
LADY3 - LADY4 - LADY5
LADY6 - LADY7 - LADY8
LADY9
Mod. DOMUS
SDOMUS03 - SDOMUS04
SDOMUS05 - SDOMUS06
SDOMUS07 - SDOMUS08
SDOMUS09 - SDOMUS10
SDOMUS12
AVAILABLE ARTICLES
Mod. SM
200SM - 250SM
1
2
Next >
55. OPERATING AND SAFETY INSTRUCTION MANUAL
03
33
65
Publicidad
