Publicidad
Idiomas disponibles
Idiomas disponibles
en
How to use the accessories
Ice-matic
Fill the ice-matics with water and put them in
place. Your ice will be ready in about two hours.
You needn't take the ice-matic out in order to
get ice; just turn it 90° to the right, and the ice
will drop into the ice-bowl below. Then take
out the ice-bowl to serve the ice. If you wish,
you can leave the ice in the bowl for a while
(Fig. 6-7).
Attention! The ice-bowl is only meant for
collecting ice. If you put water in, it will break.
Adjustable bottle racks (Fig. 8)
You can use the adjustable bottle racks by
moving them right and left. You can also move
them one into another so you don't have any
volume problem.
Fresh zone/ Second layer crisper
compartment
You can use these compartments in two
alternatives by setting the plastic slider
(Fig. 11).
• Usage as fresh zone compartment
alternative
If you push down the plastic sliders at the right
and left bottom corners as shown in the Fig.11,
the cold air flows into compartment. So this
compartment will become fresh zone
compartment. This compartment can be used
in order to put frozen food that you want to
melt and to put food before freezing
• Usage as second layer crisper
compartment alternative
If you push the plastic sliders up, the
compartment can be used as a crisper.
Note That:
-Any of the two compartments can be used as
second layer crisper while the other is adjusted
to fresh zone compartment.
- If you have adjusted the compartment at right
or left as fresh zone compartment, you can not
slide it to right or left. If you slide it, since it
becomes far away from the air channel,
required coldness can not be achieved in this
compartment.
All manuals and user guides at all-guidesbox.com
WARNING! Load food into fresh zone
compartment/ Second layer crisper according
to your selection. Otherwise your food may
face extra cooling or insufficient cooling.
You can also move fresh zone compartment/
Second layer crisper as shown in Fig.9-10
Crisper humidity controls
This feature is designed to keep your
vegetables fresh, without losing moisture
(Fig. 12). For this purpose, cold air circulates
around the crisper. The amount of cold air
passing out of the crisper can be regulated
with the controls found on the front of its cover.
You may set the humidity-control knob to the
position appropriate to the degree of moisture
and coldness of the foodstuffs inside. If you
want these to cool further, set the control to
"Open", if you want them to cool less but retain
their moisture for a long period, set it to
"Closed". Positions in between allow you to
regulate cooling and moisture-retention as
you desire.
Odor filter
The odor filter on top of your fresh food
compartment prevents formation of bad smell
in your product.
To clean the odor filter, remove the plastic
cover and leave the filter under sun light for
a day. Filter will be cleaned during this period.
Fit the filter back to its place (Fig. 13). Perform
this operation once a year.
4
en
Publicidad
