Superwinch 06212 El Manual Del Propietario página 3

INSTALLATION INSTRUCTIONS
Do not attempt to install wiring when the battery is
DANGER
!
connected. Automotive batteries contain flammable
and explosive gases. Wear eye protection during installation and
remove all metal jewelry. Do not lean over battery while making
connections.
Check to ensure that the vehicle ground and positive leads from the
battery are disconnected before performing any electrical work.
Step 1
Disconnect the battery before beginning
installation.
Step 2
Locate a place to mount the Power
Distribution Module by either using the
cable ties or screws provided.
Note: The Power Distribution Module should be located within 4
feet of the solenoid (the enclosed wires are 4 feet long; Figure 1).
Be sure to keep components away from moving
CAUTION
!
parts, sharp objects, or hot areas of the machine.
When using self-tapping screws, ensure that there
CAUTION
!
are no components, wires, or parts that can be
damaged by the screws.
Step 3
Locate a place to mount the antenna,
i.e: to rack or frame (Figure 2).
Step 4
Run wire from antenna to power
distribution module.
Step 5
Find the white 2 pin connector with the yellow and blue wires attatched.
a. Attach the wires to the solenoid using the piggy-back connectors
on the end of the wires.
3
b. Attach the blue wire to the blue marked location on the solenoid.
c. Attach the yellow wire to the yellow-marked location on the
solenoid.
d. Attach the blue and yellow wires from the handlebar switch to the
piggy-back connector matching the colors accordingly.
Step 6
Find the green 2 pin connector with the red and black wires.
a. Connect the red wire to the positive terminal on the battery.
b. Connect the black wire to the negative terminal on the battery.
Step 7
Find the green 4 pin connector with the yellow and red stripe wire.
a. Locate a wire on your ATV that turns ON and OFF with the ignition.
b. Using the attached "T tap," plug the yellow with red stripe wire
into the ignition lead.
Figure 1
Note: If you have trouble locating an ignition source, consult your dealer
or ATV owner's manual.
WARNING
!
CAUTION
!
Step 8
Secure all loose wires with cable ties.
Figure 2
Ensure that the wiring harness does not interfere
or come in contact with any hot or moving engine,
suspension, steering, braking or exhaust parts.
Do not force the plug into the socket. If it does
not plug into the socket easily, rotate the plug,
matching the tab in the socket to the keyway in
the plug.
4