Publicidad
Idiomas disponibles
Idiomas disponibles
6 Putting into operation
6.8 Testing the function
Stunning of eyes by arcs
Arcs produced when testing can damage your eyes.
► Check and wear your personal protective equipment (eye protection).
Proceed as follows to test whether the device is correctly connected:
► Insert the connection cable, switch on the power source, switch on the device, and set the welding start
signal switch to "Test".
Fig. 3 Operating panel on page EN-12
The arc will ignite for a split second.
6.9 Mounting flexible guide rails (optional)
13 Accessories on page EN-23
Required tool:
Magnetic
EN - 18
WARNING
Butt joint
Lap joint
ABICAR ADVANCED 42V
Internal hexagonal spanner AF3, AF4 and AF5
Allows movement on a surface and on tubes.
Max. rail length: 1.85 m
Min. bending radius: 1 m
Connect the flexible guide rails to the magnetic blocks
1
with a butt joint or lap joint.
Position magnets along the welding direction on the
2
workpiece.
Set the required distance on the adjustment tool.
3
Release the lever of the adjustment tool and place it on
4
the first magnet. Place the side of the stop pin against
the external edge of the material, or place the tip of
the stop pin in a groove.
Lock the lever of the adjustment tool.
5
Remove the remainder of the rail from the workpiece.
6
Move the adjustment tool along the guiding and
7
attach all magnets.
Disconnect standard guide arms from the device and
8
mount guide arms for flexible guide rails.
6.3 Positioning guide arms on page EN-16
Hang the device with the guide arms in the flexible
9
guide rails.
Publicidad
