UFESA AE4829 valley Manual De Instrucciones página 25

OPERATION METHOD
CAUTION: The vacuum must be fully charged before using for the first time.
1. Remove the vacuum cleaner from the wall mounted base. If using as a hand held unit,
disassemble the metal tube and attach the desired accessory.
2. Use the Power ON/OFF button to turn on the appliance.
3. For a stronger suction, press the speed control button to select maximum suction. You can switch to
ECO and max (turbo) speed by pressing the speed control button. The power level can be adjusted at
any moment by pressing this button.
4. To turn off the vacuum, press the Power ON/OFF button again.
Cleaning and maintenance
1. Do not use abrasive scouring pads, powders or cleaners to clean the device.
2. Use a soft, dampened and clean cloth to clean the products' outer surface.
3. Do not let water enter into the vacuum cleaner.
4. Keep the appliance in a cool, dry place and out of reach from children.
5. Do not immerse the device in water and do not clean any of its parts in the dishwasher.
Cleaning of the dust bin (Step 4)
1. Press the dust cup release button and rotate the cup clockwise.
2. Take off the dust cup from the main body.
3. Over a waste bin, press the dust release button to open the bottom cover and throw away any dust,
dirt and debris. Wipe clean only, do not submerge in water.
NOTE: It is recommended to clean the dust bin after each use. You should remove plastic filter firstly.
Cleaning of filters (Step 5)
If the filters are so dusty that suction does not return to 100%, it is suggested to be cleaned or washed.
if necessary, they can also be replaced. It is suggested to clean the filters regularly (at least once a
month) to ensure maximum efficiency. They can be cleaned with cold or warm water. It is suggested to
replace the HEPA filter twice a year. Both cleaning and replacement depends on use.
ATTENTION: Dry them thoroughly before installing them back in the unit. Allowed them to dry 24
hours by airing not near the fire or some high temperature objects before refitting into the vacuum
1. Remove the dust container from the main body.
2. Twist the steel-filter clockwise and take off the filter
3. Remove the HEPA filter from steel-filter
4. Rinse thoroughly under clean fresh water. Do not use soap or other cleaning agents.
5. Allow filter to dry naturally before placing back into the vacuum. Do not place on radiators or use
additional appliances, such as a hair dryer, to dry the filter. Doing so may cause the filter to warp or for
other irreparable damage to occur.
Cleaning of floor power brush and rollers (Step 6)
After the floor power brush has been used for a long time, its brush may wind around the hairs and the
long flosses. It is important to clean the floor power brush regularly to avoid hair and other foreign
objects from tangling, prevent blockages and ensure the vacuum cleaner can work more efficiently.
1. Pull downwards the brush roll securing clip from the brush and remove the safety brush roller clip.
2. Remove the roller from the brush housing.
3. Carefully clean and remove any hairs and fibers from the roller. Wash them under running water, do
not use harsh cleaning agents.
25