Mercusys MW300RE Guía De Instalación Rápida página 6

English
LED Explanation
(For Range Extender Mode)
Off Power is off.
The extender is starting or
Blinking
connecting to the host network.
The extender is not connected to
Solid Red
the host network.
Solid The extender is connected to the
Green host network and works well.
The extender is connected to the
Solid
host network, but is too far away
Orange
from the router.
FAQ (Frequently Asked Questions)
Q1 How do I configure the extender using
WPS?
• Plug the extender into a power outlet near
your router, and wait until the Signal LED is lit
and solid red.
• Press the WPS button on your router.
4
• Within 2 minutes, press the WPS or RESET/
WPS button on the extender. The LED
should change from blinking to a solid state,
indicating a successful WPS connection.
Q2 How do I reset the extender?
• With the extender powered on, press and
hold the Reset or RESET/WPS button until
the Signal LED turns off, then release the
button. When the Signal LED turns solid on,
the reset process is complete.
Q3 What should I do if I cannot access the
extender's web management page?
• Make sure your wireless device is
connected to the extended network using
the extended SSID.
• Verify that http://mwlogin.net is correctly
entered in the web browser.
• If you are using a computer, make sure it is
set to obtain an IP address automatically.
• Refer to Q2 to reset the extender and try
again.