Publicidad
Idiomas disponibles
Idiomas disponibles
**Please Note: Skipping this step will cause visor to vibrate against the brackets causing a rattle.**
6. Hook the visor halves over the brackets and loosely install the supplied 10-32 x ½" truss head screw and lockwasher
through the visor, into the brackets. The use of Loctite is recommended, but not supplied.
7. Loosely install a ¼-20 x 5/8" hex head bolt, washers and locknut, through the visor halves and into the center bracket.
8. Install the end bolts removed from the truck and saved in step one.
9. Adjust the visor to the desired position and tighten all hardware.
10. Peel the protective plastic and clean with glass cleaner, if necessary.
Fig. 1
Page 2 of 6
IIWS016
MAY 2016
Publicidad
