Publicidad
EN
INSTALLATION STEPS
Assemble two short boards and
one long board, then connected
by screws.
Slide one E6 washer with the flat
side toward the athlete onto each
end of T1, T2, T3, T4 athlete
bars. Repeat this step with E5
rubber bumper. Push the rubber
bumper and washer snugly
against each outside athlete.
10
Insert the bottom board into the
assembled boards of step1.
Install the bars with athletes into
the holes of the long board.
Insert the last long board right to
the position of the bars, then
screw it.
Insert six handles and six covers
into the bars, make sure that all
the handles are tightened.
Fix the parts of marker.
Install two markers into each end
side.
EN
Insert six screws into handles and
screw it.
Install two markers into each end
side.
Make sure the table is
balanceable and use the tool to
screw all nuts.
11
Publicidad
