Publicidad
Idiomas disponibles
Idiomas disponibles
Indication lamps
1
2
013836
When the protection system works during the operation,
the lamps light up.
Refer to the following table for the status and action to
be taken for the indication lamp.
Power
Battery
indicator
indicator
Blinking
Lighting Up
Blinking
013900
Nylon cutting head
NOTICE:
Do not attempt to bump feed the head while the
•
trimmer is operating at a high RPM. Bump feeding
at a high RPM may cause damage to the nylon
cutting head.
The bump feed will not operate properly if the
•
head is not rotating.
013811
The nylon cutting head is a dual grass trimmer head
provided with a bump & feed mechanism.
1. Battery indicator
2. Power indicator
Status
Battery power has been
nearly used up.
Battery protector is
shutting off the power -
battery power has been
used up.
Overheat protector is shutting
off the power - overheating.
1. Most effective
1
cutting area
Replace the battery with fully charged one.
Replace the battery with fully charged one.
Rest and cool down the equipment
for a while.
To cause the nylon cord to feed out, the cutting head should
be bumped against the ground while rotating at a low RPM.
NOTE:
If the nylon cord does not feed out while bumping the
head, rewind/replace the nylon cord by following the
procedures described under "Maintenance."
ASSEMBLY
WARNING:
Always be sure that the tool is switched off and
•
battery cartridge is removed before carrying out
any work on the trimmer. Failure to switch off and
remove the battery cartridge may result in serious
personal injury from accidental start-up.
Never start the tool unless it is completely
•
assembled. Operation of the tool in a partially
assembled state may result in serious personal
injury from accidental start-up.
9
Action to be taken
Publicidad
