Publicidad
Idiomas disponibles
Idiomas disponibles
1.Bent portion
2.Notch Nylon line
3.Intermediate separator
4.Winding direction for the
line
5.If wound unfirmly, the
line loosens.
6.Wind firmly into respec-
tive groove.
Before you start
4.
Bend the line at the point 12 cm away from the middle of
whole length and hook the bent portion into the "notch" of the
intermediate separator.
5.
Wind the line firmly into groove of the spool following "wind-
ing direction for the arrow".
6.
When the line is wound to the end hook both line ends into
respective notch of spool for retaining tentatively the line
while leaving line ends approximately 10 cm beyond notch.
7.
Align notches of spool for the line with grooves of eyelets
and fit spool into cover.
8.
Pull out the line from cover.
(A) Remove the line from "respective notch of spool", and (B)
pass it through "groove of respective eyelet".
9.
Fit cover and housing together.
(C) Align "eyelets" of cover with "recesses" of housing, and
(D) press pawls of housing into respective window of cover
until the pawls are firmly fitted into the windows.
Make sure each outer periphery of pawls of housing
spreads almost fully up to the outer periphery of respec-
tive window of cover.
If they are loosely fitted and the cutting head is turned,
cover or inside components can fly off which is danger-
ous.
19
DANGER
Publicidad
