RIDGID VAC40000 Manual Del Usuario página 7

SP6944 4 gallon ESF_SP6585 WD4050EX 3/10/15 1:41 PM Page 7
Cord and Hose Storage
1. Your Vac has a convenient area to
store your power cord and Vac hose.
2. Wrap the power cord around the top of
the handle on the Vac and attach the
end of the plug to the cord.
3. Wrap the hose around the Vac as
shown and place the small swivel end
inside the larger one.
CAUTION: A partially unwrapped
cord may fall in coils near your feet.
You could trip. To reduce the risk of
this, always fully unwrap the cord
before plugging it in.
Maintenance
Filter
WARNING: To reduce the risk of
injury from accidental starting,
unplug power cord before changing
or cleaning filter or foam pad.
NOTE: The filter is made of high quality
paper designed to stop very small
particles of dust. The filter can be used
for dry pick up or small amounts of liquid.
Handle the filter carefully when removing
to clean or installing it. Creases in the
filter pleats may occur from installation
but will not affect the performance of the
filter.
Filter Removal
1. Hold the filter tabs of the Qwik Lock™
filter in each hand.
2. With one thumb on the Qwik Lock™
stud, which protrudes through the
integrated filter plate, lift up on the filter
tabs while pushing down on the stud.
3. This action will cause the filter to
release from the filter cage. Slide filter
off cage.
.
Claw Nozzle
Compartment
Handle
Integrated Filter
DOWN
Plate with Center
Hole
Filter
Tabs (2)
Filter
Cage
IMPORTANT: To avoid damage to the
blower wheel and motor, always reinstall
the filter before using the Vac for dry
material pickup.
7
Hose
Storage
Area
Power
Cord
PUSH
PULL
UP
Rubber
Gasket at
Bottom of
Filter
(cutaway
view)
Qwik Lock™
Stud