Installation - Kenwood KDC-2022 Manual De Instrucciones

Installation

■ Installation
Firewall or metal support
Screw (M4X8)
(commercially
available)
Metal mounting strap
Self-tapping screw
(commercially available)
(commercially available)
Make sure that the unit is installed securely in place. If the unit is
unstable, it may malfunction (for example, the sound may skip).
■ Installing in Japanese-Made Cars
1
Refer to the section "Removing the hard rubber frame" (page 19)
and then remove the hard rubber frame.
2
Align the holes in the unit (two locations on each side) with the
vehicle mounting bracket and secure the unit with the accessory
screws.
Bend the tabs of the
mounting sleeve
with a screwdriver or
similar utensil and
attach it in place. • During installation, do not use any screws except for those provided.
The use of different screws might result in damage to the main unit.
• Damage may occur if a screwdriver or similar tool is used with
excessive force during the installations.
■ Screwing the Faceplate on the Unit
(KDC-2022/KDC-2022V/KDC-222/KDC-222S only)
If you want to fasten the
faceplate to the main unit so
that it does not fall off,
screw in the provided screw
(ø4 X 16 mm) in the hole
shown below.
Never insert the taptite screw (ø4 × 16 mm) in any other screw hole
than the one specified. If you screw it in another hole, it will contact
and may cause damage to the mechanical parts inside the unit.
— 18 —
N
T
N
T/N
T
ø5mm
T: Toyota cars
Accessory3...for Nissan car
N: Nissan cars
Accessory4 ...for Toyota car
8 mm
8mm
MAX.
MAX.
3
4
ø5mm
Accessory5