Water Condensation Drainage
When there is excess water condensation inside the unit, the air conditioner stops running and
shows a warning light (refer to page 10). This warning light indicates that the water condensation
needs to be drained using the following procedures:
Manual Draining
Water may need to be drained in high humidity areas
1.
Unplug the unit from power source.
2.
Place a shallow pan under the lower drain plug. See diagram.
3.
Remove the lower drain plug.
4.
Water will drain out and collect in the shallow pan.
5.
After the water is drained, replace the lower drain plug firmly.
6.
You can now turn on the unit.
Continuous Draining
While using the unit in dehumidifier mode, continuous drainage is
recommended.
1.
Unplug the unit from the power source.
2.
Remove the upper drain plug. While doing this operation some
residual water may spill so please have a pan to collect the water.
3.
Connect the drain connector to a ¾" hose (not included).
See diagram.
4.
The water can be continuously drained through the hose into a
floor drain or bucket.
5.
You can now turn on the unit.
WATER CONDENSATION DRAINAGE
Lower
Drain Plug
Shallow Pan
(Not included)
Upper
Drain Plug
Water Drain Pipe
14