GreenWorks Pro ST60L04 Manual Del Operador página 11

EN
10.5 REPLACE THE SPOOL
If any parts of the spool retainer assembly are damaged or
worn, replace the damaged part and reassemble them as
following showing
1. Disassemble the trimmer head . Pull and remove the
spool cover (b).
b
a
c
2. Clean dirt and debris from all parts. Replace spool (d) if it
is worn or damaged.
3. Loosen the screws (e). Remove the spool (d), slot covert
(f), location housing (g) from the spool assembly.
4. Replace with a new spool.
5. Insert the location housing and slot covert onto the spool
cover (b), and then put the spool onto the slot covert to
the disired position.
6. Tigthen with the screws.
e
d
f
10.6 REMOVE THE TRIMMER HEAD
1. Put the metal rod (a) in the specified angle transmission
hole (b) to fix the trimmer head.
NOTE
d
g
b
English
2. Turn the trimmer head clockwise to loosen it. Do not
remove the spacer from the shaft.
10.7 ASSEMBLE THE TRIMMER HEAD
1. Put the metal rod in the specified angle transmission hole
to fix the trimmer head.
2. Assemble the trimmer head.
3. Turn the trimmer head counterclockwise to tighten it.
4. Remove the metal rod.
You must install the cut-off blade when you use the trimmer
head.
12
a
IMPORTANT
b