Publicidad
Idiomas disponibles
Idiomas disponibles
1. ASSEMBLY INSTRUCTIONS.-
Take the unit out of its box and make
sure that all of the pieces are there:
The assistance of a second person
is recommended when assembling
this unit Fig.1.
(48) Main body.
(80) Main post.
(85) Handlebar tube.
(73) Front stabiliser bar with wheels.
(53) Rear
stabiliser
adjustable feet.
(27L) Left footrest.
(27R) Right footrest.
(31L) Pedal left foot.
(31R) Pedal right foot.
(6L) Top focus bar, left.
(6R) Top focus bar, right.
(1)
Monitor.
(17) Focus bar spindle covers (L).
(17) Focus bar spindle covers (R).
(21L) Bottom trim covers, left and
right. (L) for the knuckle joints on the
focus bars.
(21R) Bottom trim covers, left and right
(R) for the knuckle joints on the focus
bars.
(36) Bottom cover, left foot.
(36) Bottom cover, right foot.
(76) Bottom post cover.
(86) Front post cover.
(86) Rear post cover.
(92) Transformer.
Fig.2
(12)
Screws M-8x20.
(14)
Flat washer 8x36.
(3) Flat washer 19,5x38x0,5.
(94)
Spring washer M-8.
(30) Corrugated washer M-8.
(49) Self-locking nuts M8.
(52) Screw DIN 603 M-8x60.
Allen key 5 mm
Box spanner.
2. FITTING THE STABILISER
BARS.-
Bring the front stabiliser bar with wheels
(73) to the main body (48) positioning
the wheels at the front of the unit, Fig.3,
insert screws (52), the corrugated
washers (79) and the nuts (49). Use the
5mm Allen key to tighten securely.
Take the rear stabiliser bar with
adjustable feet (53), Fig.4, insert the
bar
with
bolts (52); the corrugated washers (79)
and the nuts (49) and tighten securely.
3. FITTING THE BOTTOM
POST COVER.-
Take the main post (80) and insert the
bottom post cover (76) in the direction
of the arrow, Fig.5.
4. FITTING THE MAIN POST.-
Once the bottom post cover, is fitted,
remove the screws (93) and washers
(94) and nuts (30) from the bottom of
the main post (80).
Bring the main post (80) up to boss on
the main body (48), Fig.6.
Plug connector (77), coming out of the
main post (80), into connector (74),
coming out of the boss on the main
body (48), Fig.6.
Slip the main post (80) over the boss
(48) on the main body in the direction
of the arrow, Fig.6, making sure not to
snag any of the cables.
Lower the bottom trim section (76) for
the main post (80) down over the boss
section of the main body (48), Fig.6.
5. FITTING THE FOCUS BARS.-
Insert the focus bar spindle (81)
through the spacer bushes on the
main post (80), Fig.7, leaving it
centred.
16
Publicidad
