Descargar Imprimir esta página

Danby Silhouette PROFESSIONAL SPRWC031D1SS Manual Del Propietário página 11

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATING INSTRUCTIONS
SHELF INSTRUCTIONS
Do not cover shelves with aluminum foil or any
other material as this will impede air fl ow inside the
cabinet and can adversely affect the interior cabinet
temperature.
To remove the shelves:
1. Fully extend the shelf.
2. Lift up the front of the shelf.
3. Holding the shelf track, push the shelf in and
then up to release it from the rear dampers.
STORAGE INSTRUCTIONS
The maximum capacity of this unit is 28 wine bottles
of 750 ml capacity.
Position the bottles alternately (head to tail) on the
upper six shelves. This will allow for the storage of
four 750ml bottles per shelf in each of the top six
shelves. Four additional bottles can be stored in the
bottom of the appliance.
CARE & MAINTENANCE
CLEANING
Ensure the appliance is unplugged before cleaning.
• To clean the inside of the appliance, use a soft
cloth and a solution of a tablespoon of baking
soda to one quart of water or a mild soap
solution or some mild detergent.
• Wash removable shelves in a mild detergent
solution, then dry and wipe with a soft cloth.
• Clean the outside with a soft, damp cloth and
some mild detergent.
• It is important to keep the area clean where the
door seals against the cabinet. Clean this area
with a soapy cloth. Rinse with a damp cloth and
let dry.
Note: Do not use cleaners containing ammonia or
alcohol on the appliance. Ammonia or alcohol can
damage the appearance of the appliance. Never
use any commercial or abrasive cleaners or sharp
objects on any part of the appliance.
DEFROST
This unit is equipped with an automatic defrost
function and does not require manual defrosting.
Defrost water from the appliance is channeled into
a drip tray located above the compressor. Heat
transfer from the compressor causes the defrost
water to evaporate.
DISPOSAL
This appliance may not be treated as regular
household waste, it should be taken to the
appropriate waste collection point for recycling
of electrical components. For information on local
waste collection points, contact your local waste
removal agency or government offi ce.
ERROR CODES
If the "HI", "LO" or "CL" error codes appear on the
display, press the power button once to silence the
alarm.
If the error codes reappear on the display and
remain for more than 5 minutes, a power reset
may rectify the issue. Unplug the appliance, wait 5
minutes and then plug the unit back in.
If the error code persists after a power reset, contact
consumer care or an authorized service agent.
10

Publicidad

loading