Vissani QR813 Manual Del Usuario página 12

Operation
Always turn your range hood on before you start cooking to establish good airflow in your kitchen. It is also recommended to leave the
range hood on for a few minutes after you turn off the range to clear the air .
(1) Power button activates or deactivates both the fan and the light at the same time .
(2) Fan button activates or deactivates the fan only .
(3) Plus (+) button increases the fan speed and is used to set the clock and timer . It increases the clock or timer by 1 minute each time it is
pressed or by a fixed interval when it is pressed down for longer than 2 seconds.
(4) Minus (-) button decreases the fan speed and is used to set the clock and timer . It decreases the clock or timer by 1 minute each time it
is pressed or by a fixed interval when it is pressed for longer than 2 seconds.
(5) Time button is used to set the clock and timer .
(6) Light button controls the light only . It increases light levels from Low > High > Off .
STANDBY STATE
- Once the range hood is powered it remains in a
stand by state .
TURN ON FAN
- Press the power button (1) to quickly activate both
the fan and light at once . Press the + button (3)
and - button (4) to control fan speed .
- Alternatively you can press the fan button (2) to
activate the fan only .
TURNING OFF FAN
- Press the fan button (2) or the power button (1)
while the fan is operating to deactivate it .
QR813
Fig. 12
TIMER DELAYED SHUTDOWN
- You can set a custom shut down delay time by pressing the time
button (5) and adjusting the timer using the + and - buttons .
- Pressing + and - buttons down for more than 2 seconds while in
timer setting mode will adjust the timer in 5 minute intervals to
speed up the process .
TWO LEVEL LIGHTING
- Press the light button (6) at anytime to activate the light at low
level . Press the light button (6) a second time to set the light to
high level . Press the light button (6) a third time to turn it off .
SETTING THE CLOCK
- Press and hold the time button (5) until the display starts flashing.
Press the + and - buttons to set the correct time . Press the time
button (5) again to set desired time .
- Pressing + and - buttons down for more than 2 seconds while in
clock setting mode will adjust the clock in 10 minute intervals to
speed up the process .
12