Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
Connect to power supply, push the ON/OFF button to switch on the appliance. Buzzer will have a short "D"
sound and full screen display will light up for 1 min, then automatically switch to standby mode.
Push ON/OFF button again to switch off.
Set date and time: With heater in standby mode, press SET, the day icon
flashes. Use + and – to set current day. Then press OK, the hour icon flashes, use + and – to set hour. Then press
OK, the minute icon flashes, use + and – to set minute. In the end, press OK to confirm and finish day and time
setting. (Once day is set, the current day will be highlighted.)
Manual mode: Press
- start at 1800W (screen displays
).
1) Temperature setting
- Press SET once, the screen will flash 20ºC (default temperature is 20ºC)
- Use + or – to set temperature (5-40ºC) and then press OK to confirm.
The screen will automatically display the setting temperature in working mode (SET icon and the setting
temperature will light up). Press OK to read room temperature. It will automatically switch back to setting
temperature in 5 seconds. The screen will display room temperature in standby mode or towel heating mode.
(SET icon will not light up when room temperature is displayed only).
2) Mode Switch: Press
once to switch mode among 1800W (
), 900W (
) and cooling fan(
) in
cycle. The corresponding icon will light up.
Towel Heating Function: The appliance must be in standby mode. Press
once to turn on towel heating
function, press again to turn it off. During towel heating mode, corresponding icon lights up all the time. Towel
heating working power is 200W.
Towel heating function works individually. Working time is 2 hours. It will automatically turn off in 2 hours.
Note: The temperature SET should be higher than the room temperature (the temperature icon on the left).
Otherwise, the appliance will not start heating.
Program mode: In standby mode, long press
for 3 seconds,
flashes until program setting finishes.
Set wake up time and temperature:
Screen
flashes, wake up time is setting for week days.
Press SET button, the hour icon flashes, use + and – to set hour. Press OK, the minute icon flashes, use + and –
to set minute. Then, press OK to confirm the wake up time for week-days and the temperature SET flashes. Use
+ and – to set target wake up temperature.
(During the setting, you can press SET to activate/shut down the wake up program for week-days.)
Then press OK to move on to wake up time and temperature setting for week-end,
flashes, and set the
wake up time and temperature for weekends.
(During the setting, you can press SET to activate/shut down the wake up program for weekends.)
Press OK to confirm and end the setting. All icons will stop flashing.
Notes:
1. In manual mode and program mode, press
to stop working. Towel heating function will not be affected
by this operation.
2. The appliance will not work when setting temperature is lower than ambient temperature. Towel heating
function zand cooling fan function will not be affected by this operation.
3. Long press SET for 5 seconds to recover default setting, week and time return to default setting.
9
Publicidad
