Mx Onda MX-PG2200 Manual De Usuario E Instalacion página 32

Pay special attention to the aluminum gas distributors, which should be
washed with hot water and soap or an anti-grease product, making sure
that the gas circulation slots are completely clean and that there is no
grease or impurities to obstruct them. Do not use alcohol or abrasive
products. Once clean, use a cloth to dry them, making sure they are
completely dry before placing them.
For the tempered glass surface use hot water and soap or an anti-grease
product, you can also use the specific products for the cleaning of
vitroceramic plates. Do not use scouring pads that can scratch the surface,
nor should you use abrasive products such as spray stain removers for the
ovens (Fig. 2).
To remove the most persistent adhered residues from the glass surface
you can use a scraper, not supplied (Fig. 1).
After each use you should clean the plate, in this way you will avoid that
the adhered residues burn.
The remains of foods with high sugar content attached to the glass surface
should be removed immediately to avoid deterioration of the same.
The pivots for the electric ignition 5 and the safety sensors 6, must be
carefully cleaned so as not to damage them, use a paper towel or a slightly
moistened cloth, then dry them very carefully.
PROBLEM SOLVING
If the gas cooker does not work properly or you notice an anomaly, before
calling the Official Technical Service or an Authorized Installer, perform the
following basic checks:
First, check and verify that there are no interruptions in the supply of gas and
electricity, in particular, if the gas cock is open.
The burner can not be ignited or the flame is not even around the burner.
Make sure that:
The gas holes in the burner are not obstructed.
All the moving parts of the burners are fixed correctly.
There is no strong air current around the gas plate.
6