Ryobi RY48ZTR100 Manual Del Operador página 23

REPLACING CUTTING BLADES
See Figures 19 - 20.
WARNING:
Only use replacement blades and blade bolts authorized
by the manufacturer of your riding mower. Unauthorized
blades and/or blade bolts could break, allowing the blade
to come loose, resulting in possible serious personal
injury and damage to the mower.
NOTE: Make certain all parts are replaced in the exact order
in which they were removed.
 Make sure drive levers are in open position and blade
engage knob is down.
 Stop the motor, remove the start key, and set the parking
brake.
 Raise the height of the cutting deck to its highest position
to allow access to blades.
NOTE: If necessary, raise the mower by placing on a lift
or using a jack and jack stands to gain access to the
blades.
WARNING:
If raising the mower to access the blades, make sure the
mower is properly secured and the parking brake is set
before proceeding. Failure to properly secure the mower
could cause it to fall, resulting in death or possible serious
personal injury.
 Wedge a block of wood between the blade and mower
deck to prevent the blade from turning.
 Loosen the blade nut by turning it counterclockwise (as
viewed from bottom of mower) using a 15 mm wrench
or socket (not provided).
 Remove the blade nut, spring washer, and blade.
 Place the new blade on the shaft against the corresponding
blade posts. Ensure blade is properly seated with shaft
going through center blade hole and the two blade posts
inserted into their respective holes on the blade. Make
sure it is installed with the curved ends pointing up toward
the mower deck and not down toward the ground. When
seated properly, the straight sides should be aligned and
the blade should be flat against the blade posts.
 Replace the spring washer, then thread the blade nut on
the shaft and finger tighten.
 Torque the blade nut down clockwise using a torque
wrench (not provided) to ensure the bolt is properly
tightened. The recommended torque for the blade nut is
600-650 in. lbs.
MAINTENANCE
WRENCH
BLADE
CIRCLE HOLE
WARNING:
Ensure blade is properly seated and the blade nut is
tightened to the torque specifications above. Failure to
properly attach the blade could cause it to come loose
and result in possible serious personal injury.
 Repeat with second blade, if needed.
23 — English
BLOCK OF WOOD
BLADE
CIRCLE
POST
SHAFT
CENTER
BLADE
HOLE
BLADE
NUT
SPRING
WASHER
BLADE
Fig. 19
BLADE HALF
CIRCLE POST
BLADE
HALF
CIRCLE
HOLE
BLADE
Fig. 20