Ryobi RY48ZTR100 Manual Del Operador página 33

PROBLEM
Motor stops while cutting.
Blades do not rotate.
Blades do not rotate while moving in
reverse.
Mower won't reach full speed.
Blades continue to turn after operator
leaves seat without parking brake set.
Headlights not working.
Battery will not charge.
If problem persists after trying the above solutions, contact customer service or an authorized service center for assistance.
TROUBLESHOOTING
POSSIBLE CAUSE
Cutting height set too low.
Battery charge is low.
Operator is not fully seated.
Battery charge is low.
Blade engage knob is down.
Operator is not fully seated.
Build-up of debris under mower deck.
Blade engage knob is down.
Battery charge is low.
Low speed drive feature is engaged.
Safety interlock system is not func-
tioning correctly.
Headlights are off.
Headlights are damaged.
Bad battery cells.
Poor cable connections.
33 — English
SOLUTION
Raise the cutting height.
Charge the battery.
Sit down fully on the seat, return the
drive levers to the neutral position, and
push the blade engage knob down.
Then try again.
Charge the battery.
Raise blade engage knob.
Sit down fully on the seat, return the
drive levers to the neutral position, and
push the blade engage knob down.
Then try again.
Clean underside of mower deck.
Raise blade engage knob.
Charge the battery.
Turn off low speed drive.
Ensure safety interlock system seat plug
is fully connected. If blades still won't
stop, take mower to authorized service
center for repair.
Press headlight button to turn head-
lights on.
Have headlights replaced at an autho-
rized service center.
Replace battery.
Check/clean all battery connections.