Philips Sonicare DiamondClean Smart HX9917/88 Manual página 13

2
3 1
4 6
5
20 sec.
mode DeepClean+ runs for two minutes and provides
BrushPacer feedback every 20 seconds. In non-
connected mode DeepClean+ runs for three minutes
and provides BrushPacer feedback every 30 seconds.
In order to reach optimal results, follow the
instructions below when brushing non-connected.
- Begin brushing in the upper right teeth (segment 1)
and brush for 30 seconds, on both the outer and
inner surfaces, before you move to the upper front
teeth (segment 2). Continue doing this for
segments 3 to 6 to ensure even brushing in all 6
segments of the mouth.
Tongue Care mode (specific types only)
Tongue Care is a 20-second mode, recommended to
be used with intensity level 1 and the Tongue Care+
brush head. In order to reach optimal results, follow
the instructions below:
Wet the micro bristles and brush your tongue with
1
a back and forth motion. Clean as far back as
comfortable.
2 Rinse your mouth and repeat the procedure two
more times.
Based on the brush head you attach, the mode will be
selected automatically. If you want to adjust the mode
or intensity manually, you can do this by using the
mode/intensity button. Press the mode/intensity
button before brushing to change the mode, and
press it while brushing to adjust the intensity level.
Your selection will be remembered next time you
attached the same brush head. If you want to go back
to the initial recommended settings for your brush
head, manually change it to the recommended setting
described above.
Note: When the Philips Sonicare is used in clinical
studies, it must be used at high intensity in the Clean
mode, in White+ mode, in GumHealth mode, or in
unconnected DeepClean+ mode to achieve the
efficacy in plaque removal, stain removal, gum health
or superiority (respectively).
13
English