Go Rhino 55312T Instrucciones De Instalación página 4

INSTALLATION INSTRUCTIONS
1. Install the brackets ( Sold separately ) on the vehicle.
2. Install auxiliary LED ( Sold separately ) on the skid plate as shown in
illustrations.
3. For 20" LED bar. Use the bolts (2) from the lightbar kit.
1. Tighten all the hardware to 70 in/lbs Max. DO NOT OVERTIGHTEN SCREWS.
2. Connect wiring harness according to the LED diagram.
4
REV.01
© 2017 Go Rhino Products. All rights reserved