Publicidad
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
C
HANNEL SETTINGS
AUTOSCAN
If you switch wires (e.g. between antenna and
CATV) or if you move the TV to a different area
after the initial setting, you need to perform
Autoscan again. This function lets you easily select
the receivable channels with [CH K / L ] and the TV
memorizes them even if you switch wires.
-
0
SETUP
SETUP
ENTER
ENTER
BACK
CH RETURN
VOL.
MUTE
NOTE:
• Make sure if the TV is connected to antenna or cable.
1
Display the setup screen.
• Press [SETUP].
The following setup screen is displayed.
2
Select "CHANNEL" and press [ENTER] to con-
firm.
• Using [ K / L ], select "Autoscan".
Channel
Channel
Autoscan
Channel List
Manual Register
Antenna
• Press [ENTER].
3
STILL
SCREEN
MODE
INFO
CH
For TV channels, using [ K / L ], select "Air".
For CATV channels, select "Cable".
Autoscan
Autoscan
Back
Autoscan will rescan all channels.
This may take a while to complete.
Air
Select the destination of "ANT. IN" jack.
Cable
Cable
Air
1hour
Cable
Or
ANT. IN
• Press [ENTER].
Scanning and memorizing the channels auto-
matically starts.
Now the system is scanning for channels, please wait.
72%
Analog channels
10ch
Digital channels
6ch
SETUP
Exit
• When the scanning and memorizing are com-
pleted, the smallest memorized channel in the
broadcasting will be displayed.
NOTES:
• If you connect cable system directly, contact the
CATV installer.
• If you press [POWER] or [SETUP] during Autoscan, this
setting will be canceled.
• If there is no reception connected or poor signal is detected,
a Hint will appear on screen once scanning stops.
13
EN
Publicidad
