Bosch GLL2-50 Instrucciones De Funcionamiento Y Seguridad página 13

Working with the Measuring Plate
(Accessory)
With the measuring plate 15, it is possible to
project the laser mark onto the floor or the
laser height onto a wall.
With the zero field and the scale, the offset or
drop to the required height can be measured
and projected at another location. This
eliminates the necessity of precisely
adjusting the tool to the height to
be projected.
The measuring plate 15 has a reflective
coating that enhances the visibility of the
laser beam at greater distances or in intense
sunlight. The brightness intensification can
be seen only when viewing, parallel to the
laser beam, onto the measuring plate.
Working with the Tripod (Optional
Accessory)
A tripod offers a stable, height-adjustable
measuring support. Place the tool via the
tripod mount 6 onto the 1/4" male thread of
the tripod and screw the locking screw of the
tripod tight.
Store and transport the tool only in the belt
pouch 12 or in the case 13.
Keep the tool clean at all times.
Do not immerse the tool into water or
other fluids.
Wipe off debris using a moist and soft cloth.
Do not use any cleaning agents or solvents.
Regularly clean the surfaces at the exit
opening of the laser in particular, and pay
attention to any fluff of fibers.
If the tool should fail despite the care taken in
manufacturing and testing procedures, repair
should be carried out by an authorized after-
sales service center for Bosch power tools.
Maintenance and Service
-13-
Working with the Laser Receiver
(Optional Accessory) (see figures E & H)
Under unfavorable light conditions (bright
environment, direct sunlight) and for larger
distances, use the laser receiver for
improved finding of the laser lines 16. When
working with the laser receiver, switch the
pulse function on (see "Pulse Function",
page 9).
Laser Viewing Glasses (Optional
Accessory) (see figure H)
The laser viewing glasses 14, filter out the
ambient light. This makes the red light of the
laser appear brighter for the eyes.
• Do not use the laser viewing glasses as
safety goggles. The laser viewing glasses
are used for improved visualization of the
laser beam, but they do not protect against
laser radiation.
• Do not use the laser viewing glasses as
sun glasses or in traffic. The laser
viewing glasses do not afford complete UV
protection and reduce colour perception.
In all correspondence and spare parts
orders, please always include the 10-digit
article number given on the type plate of
the tool.
For repairs, only send in the tool in the belt
pouch 12 or in the case 13.
ENVIRONMENT PROTECTION
Recycle raw materials & batteries instead of
disposing of waste. The unit, accessories,
packaging & used batteries should be sorted for
environmentally friendly recycling in accordance
with the latest regulations.