Publicidad
Idiomas disponibles
Idiomas disponibles
USE OF THE ELECTRIC SPIT
•
Remove the spit from the appliance and preheat the barbecue.
•
Evenly put the piece of meat on the spit.
•
Pierce the meat with the forks and tighten with the clamping screws. The meat should not move on
the spit. The rotation must be continuous and smooth.
•
Install the spit on the rotisserie placements provided for this purpose. The end of the pin comprising
a metal rod must be placed on the motor side, in the adapted notch. The other end, pointed, should
be placed opposite (side without motor).
•
Be sure to always put the motor pin in place before the opposite side.
•
Check that the vents of the electrical box are not obstructed by dust or any other type of foreign
material in order to avoid the risk of overheating. Overheating of the engine can cause serious injury
and burns, as well as the destruction of the motor itself.
•
Connect the motor to the mains using an extension cord. Start the engine with its switch.
•
Press the « I » button to start and « O » to stop the electric motor.
•
After cooking, turn off the power before removing the meat from the pins.
CONNECTION
•
The use of an extension cord is mandatory, so check that it is in
good electrical condition, as stipulated in the safety instructions in
this document.
•
It is advisable to make a « knot » with the plug and the extension,
as shown in the diagram opposite :
8/11/2022
EN
27
Publicidad
