Publicidad
Idiomas disponibles
Idiomas disponibles
Guide Light.
Your ET50R.E.D.™ comes equipped with a guide light at the front of the tool figure 1. The light will be activated upon pressing the trigger. Your ET50R.E.D.™ has a safety switch at the nail exit point figure 2 that will prevent your
tool from firing when not in contact with a work surface. To properly use your LED guide light, press trigger before tool makes contact with your work surface. After making contact with the work surface, release trigger, then press
trigger again to fire a nail.
You will find this helpful when firing nails into tighter corners and poorly lit areas.
figure 1
figure 2
MAINTENANCE
Your ET50R.E.D.™ is virtually maintenance free. Keep tool clean and free of dust. Wipe clean with a dry cloth do not use harsh chemicals to clean your ET50R.E.D.™.
Your ET50R.E.D.™ contains no user serviceable parts. In the unlikely event that your ET50R.E.D.™ should need service contact:
Arrow Fastener Co., LLC
271 Mayhill Street, Saddle Brook, N.J. 07663
Tel. 201 843-6900
ET50R.E.D.™
ET50R.E.D.™ for
for 220-240V
120V
& 220-240V(UK)
Use #12
Use Only An Earth Cable
LISTED
extension cord.
E216890
Extension Cord
On very hard surfaces firing recoil may
interfere with staple penetration.
Enhance driving power by firmly
placing one hand on top of cap.
BACK TO
INDEX
6
Publicidad
